The installation of SKF bearing http://www.alierbearings.com/brand/skf/index3.html  is correct and affects the accuracy, life and performance.
Therefore, the design and assembly department should fully study the installation of SKF bearing.
You want to install it according to the job criteria.
The project of the operating standard is usually as follows:
(1) to clean the bearing and bearing parts
(2) check the dimensions and precision of the connected parts
(3) installation
(4) check after the bearing is installed
(5) supply lubricant
It is hoped that the bearing packing will be opened before the installation.
General grease lubrication, no cleaning, direct filling grease.
Lubricants lubricated, common also need not wash, but, the instrument USES or high speed to use the bearing to wait, want to clean with clean oil, remove anti-rust agent that besmear on bearing.
The anti-rust agent is easy to rust, so it can't be ignored.
In addition, the bearings that have been sealed into grease are not cleaned and used directly.
The installation method of bearing is different due to bearing structure, coordination and condition. Generally, because of the rotation of the shaft, the inner circle needs to be filled.
Cylinder bore bearing, multi-purpose press pressure, or multi-purpose hot packing method.
In the case of the taper hole, install directly on the taper axis or with a sleeve.
When the shell is installed, the general clearance fit is much, and the outer ring has a surplus, usually pressing in with the press, or the cold reduction and matching method installed after cooling.
Using dry ice as a coolant, condensation and installation, the moisture in the air will condense on the surface of the bearing.
Therefore, appropriate anti-rust measures are needed